|
|
AT-64 [EURO-OBD] TROUBLE DIAGNOSIS — BASIC INSPECTION Stall Test ECS00974 STALL TEST PROCEDURE 1. Check A/T fluid and engine oil levels. If necessary, add. 2. Drive vehicle for approx. 10 minutes or until fluid and oil reach 3. Set parking brake and block wheels. 4. Install a tachometer where it can be seen by driver during test. ● It is good practice to mark the point of specified engine 5. Start engine, apply foot brake, and place selector lever in D 6. Accelerate to wide open throttle gradually while applying foot 7. Quickly note the engine stall revolution and immediately release ● During test, never hold throttle wide open for more than 5 Stall revolution: 8. Move selector lever to “N” position. 9. Cool off ATF. ● Run engine at idle for at least one minute. 10. Repeat steps 5 through 9 with selector lever in “2”, “1” and “R” positions. ATF operating temperature: 50 - 80 ° C (122 - 176 ° F) SAT647B SAT513G SAT514G QG18DE 2,300 - 2,750 rpm SAT771B |