|
|
содержание .. 1300 1301 1302 1303 ..
COLLISION DIAGNOSIS SR-33 < BASIC INSPECTION > [FOR MEXICO] C D E F G I J K L M A B SR N O P FOR SIDE AND ROLLOVER COLLISION FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision INFOID:0000000005681363 CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been 2. Replace the following components: 3. Check the SRS components and the related parts using the following table. 4. Perform self-diagnosis using CONSULT-III and “AIR BAG” warning lamp. Refer to for details. Make sure entire SRS operates properly. 5. After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRC-186, "Diagnosis Description" . Diagnosis sensor unit If none of the SRS components have been activated: Check case for dents, cracks or deformities. 2. Check connectors for damage, and terminals for deformities. 3. If no damage is found, reinstall with new fasteners. 4. If damaged − REPLACE. Install diagnosis sensor unit with new fasteners. Steering wheel 1. Visually check steering wheel for deformities. 2. Check harness (built into steering wheel) and connectors for damage, and terminals for defor- 3. Install driver air bag module into the steering wheel to check fit and alignment with the wheel. 4. Check steering wheel for excessive free play. 5. If no damage is found, reinstall. 6. If damaged − REPLACE. Spiral cable If the driver front air bag has not deployed: Visually check spiral cable and combination switch for damage. 2. Check connectors and protective tape for damage. 3. Check steering wheel for noise, binding or heavy operation. 4. If no damage is found, reinstall. 5. If damaged − REPLACE. Occupant classification system 1. Remove passenger seat assembly. 2. Check control unit case for dents, cracks of deformities. 3. Check connectors and pressure sensor tube for damage, and terminals for deformities. 4. Check seat frame and cushion pan for dents or deformities. 5. If no damage is found, reinstall seat with new fasteners. 6. If damaged − REPLACE seat cushion assembly with new fasteners. Harness and connectors 1. Check connectors for poor connection, damage, and terminals for deformities. 2. Check harness for binding, chafing, cuts, or deformities. 3. If no damage is found, reinstall the harness and connectors. 4. If damaged − REPLACE the damaged harness. Do not attempt to repair, splice or modify any SRS harness. Instrument panel assembly If the front passenger air bag has NOT deployed: Visually check instrument panel assembly for damage. 2. If no damage is found, reinstall the instrument panel assembly. 3. If damaged − REPLACE the instrument panel assembly. Part Inspection |