|
|
содержание .. 958 959 960 961 ..
LAN ADP BRANCH LINE CIRCUIT LAN-151 < DTC/CIRCUIT DIAGNOSIS > [CAN SYSTEM (TYPE 6)] C D E F G H I J K L B A O P N ADP BRANCH LINE CIRCUIT Diagnosis Procedure INFOID:0000000010092845 1. CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and con- - Driver seat control unit - Harness connector B460 - Harness connector B19 Is the inspection result normal? YES >> GO TO 2. NO >> Repair the terminal and connector. 2. CHECK HARNESS FOR OPEN CIRCUIT 1. Disconnect the connector of driver seat control unit. 2. Check the resistance between the driver seat control unit harness connector terminals. Is the measurement value within the specification? YES >> GO TO 3. NO >> Repair the driver seat control unit branch line. 3. CHECK POWER SUPPLY AND GROUND CIRCUIT Check the power supply and the ground circuit of the driver seat control unit. Refer to CONTROL UNIT : Diagnosis Procedure" Is the inspection result normal? YES (Present error)>>Replace the driver seat control unit. Refer to ADP-210, "Removal and Installation" YES (Past error)>>Error was detected in the driver seat control unit branch line. >> Repair the power supply and the ground circuit. Driver seat control unit harness connector Resistance ( Ω ) Connector No. Terminal No. B452 23 24 Approx. 54 – 66 |