Nissan Qashqai J11. Manual - part 918

PB-54

< BASIC INSPECTION >

RESET OF CLUTCH STROKE SENSOR

RESET OF CLUTCH STROKE SENSOR

Description

INFOID:0000000010833867

CAUTION:

When the following operations are performed, always use CONSULT, and carry “CLUTCH SENSOR
RESET” of “WORK SUPPORT”.

×

: Required

 —: not required

Work Procedure

INFOID:0000000010833868

CAUTION:

When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.) 
• Replacing electric parking brake control module
• Removing/installing clutch stroke sensor
• Replacing clutch stroke sensor
• Removing/installing clutch pedal
• Replacing clutch pedal

1.

CHECK THE VEHICLE STATUS

1.

Stop the vehicle.

2.

Stop the engine.

3.

Turn the ignition switch OFF.

>> GO TO 2.

2.

CHECKING INSTALLATION CONDITION OF CLUTCH COMPONENTS

Check the installation conditions of clutch components.
Is the inspection result normal?

YES

>> GO TO 3.

NO

>> Repair or replace error-detected parts and GO TO 3.

3.

PERFORM CLUTCH SENSOR RESET

CAUTION:

• Never allow passenger or load on the vehicle.
• Never apply vibration to the vehicle body when opening or closing door during calibration.

With CONSULT

1.

Turn the ignition switch ON.

Procedure

CLUTCH SENSOR RESET

Removing/installing electric parking brake control module

—

Replacing electric parking brake control module

×

Removing/installing rear brake pad (When not pressing piston of rear 
brake caliper assembly)

—

Removing/installing rear brake pad (When pressing piston of rear brake 
caliper assembly)

—

Replacing rear brake pad

—

Removing/installing rear brake caliper assembly

—

Replacing rear brake caliper assembly

—

Removing/installing parking brake switch

—

Replacing parking brake switch

—

Removing/installing clutch stroke sensor

×

Replacing clutch stroke sensor

×

Removing/installing clutch pedal

×

Replacing clutch pedal

×

OPERATION OF REAR BRAKE CALIPER

PB-55

< BASIC INSPECTION >

C

D

E

G

H

I

J

K

L

M

A

B

PB

N

O

P

OPERATION OF REAR BRAKE CALIPER

Description

INFOID:0000000010833869

CAUTION:

When the following operations are performed, always use CONSULT, for performing “BRAKE OPERA-
TION” of “WORK SUPPORT”.

×

: Required

 —: not required

Work Procedure

INFOID:0000000010833870

CAUTION:

When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.) 
• Removing/installing electric parking brake control module
• Replacing electric parking brake control module
• Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly)
• Removing/installing rear brake pad (When pressing piston of rear brake caliper assembly)
• Replacing rear brake pad
• Removing/installing rear brake caliper assembly
• Replacing rear brake caliper assembly
NOTE:
When the replaced rear brake pad, refer to 

PB-46, "Work Procedure"

.

1.

PERFORM BRAKE OPERATION

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE OPERATION” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

2.

Touch “START”.

>> GO TO 2.

2.

PERFORM BRAKE RELEASE

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE RELEASE” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

Procedure

BRAKE OPERATION

Removing/installing electric parking brake control module

×

Replacing electric parking brake control module

×

Removing/installing rear brake pad (When not pressing piston of rear 
brake caliper assembly)

×

Removing/installing rear brake pad (When pressing piston of rear brake 
caliper assembly)

×

Replacing rear brake pad

×

Removing/installing rear brake caliper assembly

×

Replacing rear brake caliper assembly

×

Removing/installing parking brake switch

—

Replacing parking brake switch

—

Removing/installing clutch stroke sensor

—

Replacing clutch stroke sensor

—

Removing/installing clutch pedal

—

Replacing clutch pedal

—

PB-56

< BASIC INSPECTION >

OPERATION OF REAR BRAKE CALIPER

OPERATION OF REAR BRAKE CALIPER

Description

INFOID:0000000010833869

CAUTION:

When the following operations are performed, always use CONSULT, for performing “BRAKE OPERA-
TION” of “WORK SUPPORT”.

×

: Required

 —: not required

Work Procedure

INFOID:0000000010833870

CAUTION:

When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.) 
• Removing/installing electric parking brake control module
• Replacing electric parking brake control module
• Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly)
• Removing/installing rear brake pad (When pressing piston of rear brake caliper assembly)
• Replacing rear brake pad
• Removing/installing rear brake caliper assembly
• Replacing rear brake caliper assembly
NOTE:
When the replaced rear brake pad, refer to 

PB-47, "Work Procedure"

.

1.

PERFORM BRAKE OPERATION

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE OPERATION” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

2.

Touch “START”.

>> GO TO 2.

2.

PERFORM BRAKE RELEASE

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE RELEASE” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

Procedure

BRAKE OPERATION

Removing/installing electric parking brake control module

×

Replacing electric parking brake control module

×

Removing/installing rear brake pad (When not pressing piston of rear 
brake caliper assembly)

×

Removing/installing rear brake pad (When pressing piston of rear brake 
caliper assembly)

×

Replacing rear brake pad

×

Removing/installing rear brake caliper assembly

×

Replacing rear brake caliper assembly

×

Removing/installing parking brake switch

—

Replacing parking brake switch

—

Removing/installing clutch stroke sensor

—

Replacing clutch stroke sensor

—

Removing/installing clutch pedal

—

Replacing clutch pedal

—

RELEASE OF REAR BRAKE CALIPER

PB-57

< BASIC INSPECTION >

C

D

E

G

H

I

J

K

L

M

A

B

PB

N

O

P

RELEASE OF REAR BRAKE CALIPER

Description

INFOID:0000000010833871

CAUTION:

When the following operations are performed, always use CONSULT, for performing “BRAKE
RELEASE” of “WORK SUPPORT”.

×

: Required

 —: not required

Work Procedure

INFOID:0000000010833872

CAUTION:

When the following operations are performed, always use CONSULT. (It cannot be performed by any
means other than CONSULT.) 
• Removing/installing electric parking brake control module
• Replacing electric parking brake control module
• Removing/installing rear brake pad (When not pressing piston of rear brake caliper assembly)
• Removing/installing rear brake pad (When pressing piston of rear brake caliper assembly)
• Replacing rear brake pad
• Removing/installing rear brake caliper assembly
• Replacing rear brake caliper assembly
NOTE:
When the replaced rear brake pad, refer to 

PB-46, "Work Procedure"

.

1.

PERFORM BRAKE OPERATION

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE OPERATION” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

2.

Touch “START”.

>> GO TO 2.

2.

PERFORM BRAKE RELEASE

With CONSULT

1.

Select “EHS/PKB”, “WORK SUPPORT”, and “BRAKE RELEASE” according to this order.

CAUTION:

• Never operate the parking brake switch.
• Never depress the brake pedal.

Procedure

BRAKE RELEASE

Removing/installing electric parking brake control module

×

Replacing electric parking brake control module

×

Removing/installing rear brake pad (When not pressing piston of rear 
brake caliper assembly)

×

Removing/installing rear brake pad (When pressing piston of rear brake 
caliper assembly)

×

Replacing rear brake pad

×

Removing/installing rear brake caliper assembly

×

Replacing rear brake caliper assembly

×

Removing/installing parking brake switch

—

Replacing parking brake switch

—

Removing/installing clutch stroke sensor

—

Replacing clutch stroke sensor

—

Removing/installing clutch pedal

—

Replacing clutch pedal

—