Nissan Qashqai J11. Manual - part 876

WT-50

< SYMPTOM DIAGNOSIS >

[WITH TPMS]

LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN OFF

LOW TIRE PRESSURE WARNING LAMP DOES NOT TURN OFF

Description

INFOID:0000000010339555

The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.

Diagnosis Procedure

INFOID:0000000010339556

1.

CHECK TIRE PRESSURE

1.

Turn the ignition switch ON.

CAUTION:

Never start the engine.

2.

Check the tire pressure for all wheels and adjust to the specified value. Refer to 

WT-66, "Tire Air Pres-

sure"

. 

3.

Perform TPMS temperature calibration. Refer to 

WT-14, "TPMS temperature calibration"

.

4.

Recheck the tire pressure for all wheels. Refer to 

WT-66, "Tire Air Pressure"

. 

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Inspect or repair the tires or wheels.

2.

CHECK LOW TIRE PRESSURE WARNING LAMP OPERATION

Check that the low tire pressure warning lamp is turned OFF after turns ON for approximately 1 second, when
the ignition switch is turned ON.

Is the inspection result normal?

YES

>> INSPECTION END

NO

>> GO TO 3.

3.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “AIR PRESSURE MONITOR”.

Is DTC detected?

YES

>> Perform DTC diagnosis procedure. Refer to 

BCS-90, "DTC Index"

.

NO

>> GO TO 4.

4.

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for power supply and ground circuit. Refer to 

BCS-125, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Replace BCM. Refer to 

BCS-132, "Removal and Installation"

. 

NO

>> Repair or replace error-detected parts.

LOW TIRE PRESSURE WARNING LAMP BLINKS

WT-51

< SYMPTOM DIAGNOSIS >

[WITH TPMS]

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

LOW TIRE PRESSURE WARNING LAMP BLINKS

Description

INFOID:0000000010339557

When the ignition switch is turned ON, the low tire pressure warning lamp blinks. And then 1 minute later, low
tire pressure warning lamp turns ON.

Diagnosis Procedure

INFOID:0000000010339558

1.

CHECK TIRE PRESSURE SENSOR INSTALLATION 

Check visually that tire pressure sensors are installed to each wheels correctly.
NOTE:
In the following case, tire pressure monitoring system (TPMS) does not function.
• Tire pressure sensor(s) are not installed. 
• Tire pressure sensor(s) of other cars are installed. 

Are the genuine NISSAN tire pressure sensors are installed correctly? 

YES

>> GO TO 2.

NO

>> Replace and/or Install tire pressure sensor(s). Refer to 

WT-62, "Removal and Installation"

. GO TO

3.

2.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “AIR PRESSURE MONITOR”.

Is DTC detected?

YES

>> Perform DTC diagnosis procedure. Refer to 

BCS-90, "DTC Index"

.

NO

>> GO TO 4.

3.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to 

WT-29, "Work Procedure"

.

Is tire pressure sensor ID registration completed?

YES

>> Adjust the tire pressure for all wheels specified to the value. Refer to 

WT-66, "Tire Air Pressure"

.

And perform TPMS temperature calibration. Refer to 

WT-14, "TPMS temperature calibration"

.

INSPECTION END

NO

>> Perform diagnosis procedure of “TIRE PRESSURE SENSOR ID REGISTRATION CANNOT BE

COMPLETED”. Refer to 

WT-54, "Diagnosis Procedure"

.

4.

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for power supply and ground circuit. Refer to 

BCS-125, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Replace BCM. Refer to 

BCS-132, "Removal and Installation"

. 

NO

>> Repair or replace error-detected parts.

WT-52

< SYMPTOM DIAGNOSIS >

[WITH TPMS]

LOW TIRE PRESSURE LOCATION INDICATOR DOES NOT DISPLAY

LOW TIRE PRESSURE LOCATION INDICATOR DOES NOT DISPLAY

Description

INFOID:0000000010339559

When low tire pressure, low tire location indicator does not display though low tire pressure warning lamp
turns ON.

Diagnosis Procedure

INFOID:0000000010339560

1.

CHECK COMBINATION METER

Check combination meter. Refer to 

MWI-54, "Work flow"

.

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Repair or replace error-detected parts.

2.

CHECK LOW TIRE PRESSURE WHELL LOCATION INDICATOR OPERATION

Check that the low tire pressure location indicator is turned OFF after turns ON for approximately 1 second,
when the ignition switch is turned ON.
Is the inspection result normal?

YES

>> Check intermittent incident. Refer to 

GI-41, "Intermittent Incident"

.

NO

>> Replace the BCM. Refer to 

BCS-132, "Removal and Installation"

.

LOW TIRE PRESSURE LOCATION INDICATOR CONTINUES DISPLAYING

WT-53

< SYMPTOM DIAGNOSIS >

[WITH TPMS]

C

D

F

G

H

I

J

K

L

M

A

B

WT

N

O

P

LOW TIRE PRESSURE LOCATION INDICATOR CONTINUES DISPLAYING

Description

INFOID:0000000010339561

The low tire pressure location indicator continues displaying though low tire pressure warning lamp turns/stays
OFF.

Diagnosis Procedure

INFOID:0000000010339562

1.

CHECK TIRE PRESSURE

1.

Turn the ignition switch ON.

CAUTION:

Never start the engine.

2.

Check the tire pressure for all wheels and adjust to the specified value. Refer to 

WT-66, "Tire Air Pres-

sure"

. 

3.

Perform TPMS temperature calibration. Refer to 

WT-14, "TPMS temperature calibration"

.

Is the inspection result normal?

YES

>> GO TO 2.

NO

>> Inspect or repair the tires or wheels.

2.

CHECK LOW TIRE PRESSURE LOCATION INDICATOR

Check low tire pressure location indicator.

Does low tire pressure location indicator continues displaying?

YES

>> GO TO 3.

NO

>> INSPECTION END

3.

PERFORM SELF-DIAGNOSIS

With CONSULT

Perform self-diagnosis for “AIR PRESSURE MONITOR”.
Is DTC detected?

YES

>> Perform DTC diagnosis procedure. Refer to 

WT-20, "DTC Index"

.

NO

>> GO TO 4.

4.

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Perform the trouble diagnosis for power supply and ground circuit. Refer to 

BCS-125, "Diagnosis Procedure"

.

Is the inspection result normal?

YES

>> Replace BCM. Refer to 

BCS-132, "Removal and Installation"

. 

NO

>> Repair or replace error-detected parts.