Nissan Qashqai J11. Manual - part 335
P1197 OUT OF GAS
ECM-317
< DTC/CIRCUIT DIAGNOSIS >
[MR20DD]
C
D
E
F
G
H
I
J
K
L
M
A
ECM
N
P
O
P1197 OUT OF GAS
DTC Description
INFOID:0000000010703008
This diagnosis result is detected when the fuel level of the fuel tank is extremely low and the engine does
notrun normally.
DTC DETECTION LOGIC
POSSIBLE CAUSE
• Fuel cut
• Harness or connectors (Fuel pump circuit is open or shorted.)
• Fuel pump
• Fuel pressure regulator
• Fuel pump system
• Harness or connectors (High pressure fuel pump circuit is open or shorted.)
• High pressure fuel pump
• High pressure fuel pump system
• Fuel rail pressure sensor
• Hose disconnection
FAIL-SAFE
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure
before conducting the next test.
1.
Turn ignition switch OFF and wait at least 10 seconds.
2.
Turn ignition switch ON.
3.
Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
>> GO TO 2.
2.
PERFORM DTC CONFIRMATION PROCEDURE-1
Start the engine.
Does the engine start?
YES
>> GO TO 3.
NO
>> Proceed to
ECM-318, "Diagnosis Procedure"
.
3.
PERFORM DTC CONFIRMATION PROCEDURE-2
1.
Start engine and warm it up to normal operating temperature.
NOTE:
For best results, warm up the engine until “COOLAN TEMP/S” on “DATA MONITOR” mode of “ENGINE”
using CONSULT reaches at least 70
°
C (158
°
F).
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P1197
FUEL RUN OUT
• Fuel rail pressure remains at 1.1 MPa (11 bar, 11.2 kg/cm
2
, 159.5 psi) or
less for 5 seconds or more with the fuel level too low.
• Fuel rail pressure remains 2.7 MPa (27 bar, 27.5 kg/cm
2
, 392 psi) lower
than a target fuel pressure for 5 seconds or more with the fuel level too
low.
Engine operating condition in fail-safe mode
Fail safe mode
Vehicle behavior
Others
Engine torque is limited.