Mitsubishi Outlander (2003+). Manual - part 32
ENGINE ASSEMBLY
ENGINE MECHANICAL <4G69>
11C-55
>>B<< ENGINE FRONT MOUNTING BRACKET
INSTALLATION
1. Place a garage jack against the engine oil pan
with a piece of wood in between, and install the
engine front mounting bracket while adjusting the
position of the engine.
2. Support the engine assembly with a garage jack.
3. Remove the chain block.
4. Use the following special tool as during removal to
support the engine.
(1) <Special tool engine hanger (MB991895) is
used>
Set special tool MB991895. (M/T: Refer to
GROUP 22A, Transmission Assembly
, A/T: Refer to GROUP 23A,
Transmission Assembly
).
(2) <Special tool engine hanger (MB991928) is
used>
Set special tool MB991928. (M/T: Refer to
GROUP 22A, Transmission Assembly
, A/T: Refer to GROUP 23A,
Transmission Assembly
).
>>C<< SELF-LOCKING NUTS INSTALLATION
CAUTION
Do not tighten the self-locking nuts while the
engine is hot.
Tighten the self-locking nuts to the specified torque
while the engine is cold.
Tightening torque: 45
±
5 N
⋅
m
>>D<< TRANSMISSION ASSEMBLY
INSTALLATION
1. Install the transmission assembly. (M/T: Refer to
GROUP 22A, Transmission Assembly
A/T: Refer to GROUP 23A, Transmission
Assembly
2. Remove from the car the two bolts, to assemble
the radiator support upper insulator.
>>E<< FUEL HIGH-PRESSURE HOSE
INSTALLATION
CAUTION
After connecting the fuel high-pressure hose,
slightly pull it to ensure that it is installed
securely. Also confirm that there is a play
approximately 3 mm. Then install the stopper
securely.
Apply a small amount of engine oil to the fuel line
pipe and then install the fuel high-pressure hose.
AC107631AB
MB991527
MB991454
MB991895
AC211405AB
MB991527
MB991454
MB991928
AC300950
AB
AC301864AB
3 mm
Fuel
high-pressure
hose
Fuel line pipe
(Engine oil applied)
AC304583
AB
Stopper