|
|
ENGINE LUBRICATION – On-vehicle Service 12-6 4. Install the oil pressure gauge. NOTE 5. Run the engine to warm it. 6. After the engine has been warmed up, check that oil Standard value: At idle: 29 kPa or more At 3,500 r/min: 294 – 686 kPa 7. Remove the oil pressure gauge. 8. Apply the specified sealant to the thread of oil pressure Specified sealant: 3M ATD Part No. 8660 or equivalent 9. Use the special tool to tighten the oil pressure switch Tightening torque: 19 Nm Caution 10. Install the oil pressure switch terminal. MD998054 |