|
|
6E-202 Engine Control System (4HK1) 13 1. Turn OFF the ignition. 2. Disconnect the ECM harness connector. 3. Inspect for an intermittent and for a poor 4. Repair the connection(s) as necessary. Did you find and correct the condition? — Go to Step 16 Go to Step 15 14 Replace the starter cut relay. Did you complete the replacement? — Go to Step 16 — 15 Important: Replace the ECM. Refer to Engine Control Module Did you complete the replacement? — Go to Step 16 — 16 1. Reconnect all previously disconnected fuse, 2. Clear the DTCs with the Tech 2. 3. Turn OFF the ignition for 30 seconds. 4. Turn ON the ignition for 5 seconds. 5. Start the engine. Did the DTC fail this ignition? — Go to Step 2 Go to Step 17 17 Observe the DTC Information with the Tech 2. Are there any DTCs that you have not diagnosed? — Go to Diagnostic Trouble Code (DTC) List System OK Step Action Value(s) Yes No |