|
|
Automatic Transmission – 4L60E – Electrical Diagnosis Page 7C2–86 Step Action Yes No 14 Perform the following procedure to verify the repair: 1 On Tech 2 select: 2 Follow the instructions on Tech 2 and clear any DTCs. 3 On Tech 2 select: 4 Operate the vehicle under the following conditions: • Drive the vehicle in D4, with the TCC on, and a throttle • On Tech 2 ensure the TCC Slip Speed is -20 to +50 RPM 5 On Tech 2 select: Has DTC P0894 set? Go to Step 2 Go to Step 15 15 On Tech 2 select: Diagnostic Trouble Codes / Read DTC Information. Does Tech 2 display any DTCs you have not diagnosed? Refer to 4.8 Diagnostic Trouble Code List System OK When all diagnosis and repairs are completed, check the system for correct operation. 4.27 DTC P0961 – Line Pressure Control Solenoid System Performance DTC Description This diagnostic procedure supports DTC P0961 Line Pressure Control (PC) Solenoid System Performance. Circuit Description The pressure control (PC) solenoid valve is an electronic device that regulates transmission line pressure based on the When the TCM detects a continuous open or short to ground in the PC solenoid valve circuit, then DTC P0961 sets. Refer to 2 Wiring Diagrams and Connector Chart to aid in diagnosis. Conditions for Running the DTC • The system voltage is 8 – 18 V. • The engine is running. Conditions for Setting the DTC The PC solenoid valve duty cycle reaches its high limit, approximately 95 percent, or low limit, approximately 2 percent. Action Taken When the DTC Sets • The TCM does not request the engine control module (ECM) to illuminate the MIL. |