|
|
ENGINE CONTROL SYSTEM (4JK1/4JJ1) 6E-131 Circuit/ System Testing DTC P0203 10 Important: Replacement ECM must be Did you complete the replacement? — Go to Step 11 — 11 1. Reconnect all previously disconnected 2. Clear the DTCs with a scan tool. 3. Turn OFF the ignition for 30 seconds. 4. Start the engine. 5. Operate the vehicle within the Conditions for Did the DTC fail this ignition? — Go to Step 3 Go to Step 12 12 Observe the DTC Information with a scan tool. Are there any DTCs that you have not diagnosed? — Go to DTC List System OK Step Action Value(s) Yes No Step Action Value(s) Yes No 1 Did you perform the Diagnostic System Check - — Go to Step 2 Go to Diagnostic System Check - 2 1. Install a scan tool. 2. Turn OFF the ignition for 30 seconds. 3. Start the engine. 4. Monitor the DTC Information with a scan tool. Does the DTC fail this ignition? — Go to Step 3 Go to Diagnostic Aids 3 1. Turn OFF the ignition. 2. Disconnect the cylinder #3 fuel injector 3. Inspect for an intermittent and for poor 4. Repair the connection(s) as necessary. Did you find and correct the condition? — Go to Step 11 Go to Step 4 4 Measure the resistance of cylinder #3 fuel injector Is the resistance less the specified value? 2.0 Ω Go to Step 5 Go to Step 9 5 1. Disconnect the cylinder #2 fuel injector 2. Measure the resistance of the charge voltage Is the resistance less than the specified value? 1.0 Ω Go to Step 6 Go to Step 7 |