|
|
FRONT COIL SPRING AND SHOCK ABSORBER FSU-9 < ON-VEHICLE REPAIR > [2WD] C D F G H I J K L M A B FSU N O P ON-VEHICLE REPAIR FRONT COIL SPRING AND SHOCK ABSORBER Exploded View INFOID:0000000000957767 Removal and Installation INFOID:0000000000957768 REMOVAL 1. Remove tires with power tool. 2. Remove harness of the wheel sensor from shock absorber. CAUTION: Never pull on wheel sensor harness. 3. Remove brake hose bracket. Refer to BR-37, "Removal and Installation" . 4. Remove mounting nuts on the lower side of stabilizer connecting rod with power tool. 5. Remove mounting nuts on upper side of stabilizer connecting rod with power tool, and then remove stabi- 6. Separate upper link from steering knuckle. 7. Remove mounting nuts of shock absorber mounting bracket, then remove shock absorber assembly. INSTALLATION Note the following, and install in the reverse order of removal. CAUTION: Never tap on the ball joint cap of the stabilizer connecting rod with a hammer or a similar item when conditions with tires on level ground. Disassembly and Assembly INFOID:0000000000957769 DISASSEMBLY CAUTION: Never damage shock absorber piston rod when removing components from shock absorber. 1. Install strut attachment (A) [SST: ST35652000 ( – )] to shock absorber and secure it in a vise. CAUTION: When installing the strut attachment to shock absorber, 2. Using a spring compressor (A) (commercial service tool), com- CAUTION: Be sure a spring compressor is securely attached coil 3. Make sure coil spring with a spring compressor between rubber JPEIA0006ZZ JPEIA0007ZZ |