|
|
Content .. 1388 1389 1390 1391 ..
STEERING GEAR AND LINKAGE ST-41 < ON-VEHICLE REPAIR > C D E F H I J K L M A B ST N O P a. Apply thread sealant into the thread of inner socket. GI-15, "Recommended Chemical Products and 9. Decide on the neutral position of the rack stroke (L). 10. Install rear cover cap to gear sub-assembly. CAUTION: Make sure that the projection of rear cover cap is aligned 11. Apply recommended thread locking sealant to the thread (2 turns thread), and then screw in the adjusting screw until it 12. Move rack assembly 10 strokes throughout the full stroke so that the parts can fit with each other. 13. Adjust pinion rotating torque with the following procedure. a. Measure pinion rotating torque within ± 180 ° of neutral position of the rack assembly using tools. Stop the gear at the point b. Loosen adjusting screw and retighten to 5.4 N·m (0.55 kg-m, 48 ° . c. Measure pinion rotating torque using tools to make sure that the d. Apply recommended liquid gasket to inner socket and turn pinion fully to left with inner socket installed to Standard L : Refer to . SGIA0877E SGIA0624E A: Preload gauge [SST: ST3127S000 (J-25765-A)] B: Preload adapter [SST: KV48103400 ( — )] SGIA1383E Pinion rotating torque Around neutral position ± 100 ° ) average (A) : 1.3 – 2.5 N·m (0.14 – 0.25 Maximum variation (B) : 3.0 N·m (0.31 kg-m, 27 PGIA0066E |