213

IV. HEADLAMP BEAM ADJUSTMENT

LOW BEAM

1. Adjust the condition of the vehicle.

y

Make sure the body around the headlamp is not deformed

y

Tire inflation pressure is the specified value

y

Park the no-load vehicle on a level spot

y

Sit on the driver's seat and be ready for driving (with a full fuel tank)

y

Put the vehicle in front of a wall, and let it be perpendicular to the wall

y

Ensure the distance from the headlamps to the wall is 10 m

2. Inspect the headlamp beam

y

Set up a screen as shown in the illustration, to adjust the headlamp aim

y

Cover the other lamps while a certain headlamp is adjusted.

y

Start the engine

y

Turn the headlamp low beam ON

y

Then turn the adjusting screws controlling the beams. Make the main beam (the brightest point) at

the specified height, that is, the corner point of the "cut-off" line is located in the center of the

shaded part, as shown in the illustration.

Low Beam Lay

Dim and Bright 
Cut Line Angle

Distance from the central point of 
the headlamp beam to the ground

Low 
Beam

Position of the Vehicle

214

NOTICE:

The screw must be tightened when adjusting the headlamps. If it needs loosening for adjusting, you should

completely loosen it and then begin to tighten it.

(1) Adjust the positions of the screw bolts, as shown in the illustration below.

y

Turn A for adjustment in horizontal direction within an allowed scope.

y

Turn B for adjustment in vertical direction within an allowed scope.

V LH

V RH

V-line

Central of the Headlamp

Central of the Headlamp

Corner Point of 
the "Cut-off" Line

Dim and Bright 
Cut Line Angle

A

B

215

Section 4 Front Fog Lamp Replacement

I. REMOVAL

1. Remove the front bumper.(See bumper replacement)

2. Remove the electrical connector.

3. Remove the mounting bolts (A, B as shown in the illustration).

4. Remove the front fog lamp assembly.

II. INSTALLATION

1. Install the front fog lamp assembly.

2. Install the mounting bolts.

3. Install the electrical connector.

4. Install the front bumper.

5. Adjust the condition of the vehicle.

6. Adjust the front fog lamp beam.

III. FRONT FOG LAMP BULB REPLACEMENT

1. Press and Turn counter-clockwise, then remove the dust cover

2. Pull out the bulb

3. Replace the bulb

A

B

Electrical 
Connection

216

IV. FRONT FOG LAMP BEAM ADJUSTMENT

1. Adjust the tire inflation pressure with the standard value

2. Start the engine

3. Turn the fog lamp switch ON

4. Adjust the fog lamp beam.

Turn the bolt A for adjusting fog lamp beam in vertical direction.

NOTES:

Turn the screwdriver counter-clockwise to make the light beam up, clockwise make the light beam down.