|
|
1. Disconnect and isolate the battery negative cable. 2. Remove the driver side airbag (5) from the steering wheel (1) (Refer to 8 - ELECTRICAL/RE- STRAINTS/DRIVER AIRBAG - REMOVAL). 3. Remove the speed control switch (3) or (6) located on the same side of the steering wheel as the 4. Disconnect the steering wheel wire harness con- nector from the connector receptacle of the remote 5. Disengage the four remote radio switch latches that secure the switch to the inside of the mounting 6. From the outside of the steering wheel rear trim cover, remove the remote radio switch (2) from the INSTALLATION 1. Position the remote radio switch (2) to the mount- ing hole on the outside of the steering wheel rear 2. Press firmly and evenly on the remote radio switch until each of the switch latches is fully engaged in 3. Connect the steering wheel wire harness connector to the connector receptacle of the remote radio 4. Install the speed control switch (3) or (6) onto the steering wheel (Refer to 8 - ELECTRICAL/SPEED 5. Install the driver side airbag (5) to the steering wheel (Refer to 8 - ELECTRICAL/RESTRAINTS/ 6. Connect the battery negative cable. 8A - 198 AUDIO/VIDEO - SERVICE INFORMATION ND |