|
|
Content .. 1204 1205 1206 1207 ..
INSTALLATION 1. Slide the upper retaining tab of the upper B-pillar trim panel (3) into the hole in the B-pillar (1) and 2. Position the seat belt (6) turning loop onto the height adjuster (2) on the upper B-pillar. 3. Install the screw (5) that secures the turning loop to the height adjuster. Tighten the screw to 39 N·m 4. Engage the upper edge of a trim cover (4) over the top of the turning loop. Then, squeeze the lower 5. Position the seat belt (1) lower anchor to the mounting hole on the outboard side of the front 6. Install the screw (3) that secures the lower anchor to the outboard side of the front seat cushion PANEL-C PILLAR LOWER TRIM REMOVAL Club Cab, Without Rear Jumper Seats 1. Adjust the front seat to its most forward position. 23 - 236 INTERIOR ND |