|
|
Content .. 1173 1174 1175 1176 ..
INSTALLATION 1. Place the regulator into the door and engage the bolts (2) into the keyhole slots in the door. 2. Install the one bolt at the motor and the two lower bolts (4). 3. Tighten all the regulator bolts to 10 N·m (85 in. lbs.). 4. Connect the electrical connector (3). 5. Remove the tape used to secure the glass during removal and position the glass (1) into the glass 6. Temporarily install the window switch and raise the glass into the full up position. 7. Tighten the glass clamp screws (2) securely. 8. Remove the window switch and install the water- shield. (Refer to 23 - BODY/DOORS - REAR/WA- 23 - 112 DOORS - REAR ND |