Refer to (Fig. 1), (Fig. 2), (Fig. 3), (Fig. 4) or (Fig.
5)for proper location of fasteners holding the molding to the wheelhouse lip and rocker panels.
(1) Warm the affected stick on molding and body
metal to approximately 38° C (100° F) using a suit- able heat lamp or heat gun.
(2) If equipped, remove pop rivets holding molding
edge to wheelhouse lip.
(3) Pull stick on molding from painted surface. (4) Remove adhesive tape residue from painted
surface of vehicle. Use a 3M Scotch-Brite™ Molding Adhesive and Stripe Removal Disc, or equivalent, to clean adhesive residue from painted surfaces. These products are available from automotive paint suppli- ers. Refer to instructions supplied with the specific product for proper usage.