TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Ignition on, engine not running.
With the DRBIII
t, monitor the MAP Sensor voltage.
Is the voltage above 1.2 volts?
All
Yes
→ Replace the MAP Sensor.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 4
4
Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between ground and the (K1) MAP Signal circuit at the MAP
Sensor harness connector.
Is the resistance below 100 ohms?
All
Yes
→ Repair the short to ground in the (K1) MAP Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 5
5
Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the (K1) MAP Signal circuit and the (K4) Sensor
ground circuit in the MAP Sensor harness connector.
Is the resistance below 100 ohms?
All
Yes
→ Repair the (K4) Sensor ground shorted to the (K1) MAP Signal
circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 6
6
NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
All
Repair
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
7
Turn the ignition off.
Disconnect the MAP Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K6) 5 Volt Supply circuit in the MAP Sensor harness
connector to ground.
Is the resistance below 100 ohms?
All
Yes
→ Repair the short to ground in the (K6) 5 Volt Supply circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 8
54
DRIVEABILITY - NGC
P0107-MAP SENSOR LOW —
Continued