|
|
Symptom: MEMORY POSITION SWITCH STUCK When Monitored and Set Condition: MEMORY POSITION SWITCH STUCK When Monitored: Anytime the Body Control Module is awake. Set Condition: If the Memory switch is active for over 10 seconds, the BCM will set this code. POSSIBLE CAUSES DTC PRESENT MEMORY SET SWITCH STUCK MEMORY SELECT SWITCH MUX SHORT TO GROUND BODY CONTROL MODULE TEST ACTION APPLICABILITY 1 With the DRBIII t, record and erase DTC’s. Cycle the ignition OFF then back ON. t, read DTCs. Operate the Memory Set switch several times while monitoring the DRBIII. t display MEMORY SWITCH INPUT STUCK? All Yes → Go To 2 No → Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. 2 Disconnect the Memory Set Switch connector t in Sensors, read the Memory Select SW Volts. Is the voltage above 4.8 volts? All Yes → Replace the Memory Set Switch. Perform MEMORY SYSTEM VERIFICATION TEST - VER 1. No → Go To 3 3 Turn the ignition off. All Yes → Go To 4 No → Repair the Memory Select Switch MUX circuit for a short to ground. 865 MEMORY SEAT |