|
|
Symptom: DRIVER REAR WINDOW SWITCH MUX INPUT STUCK - DDM When Monitored and Set Condition: DRIVER REAR WINDOW SWITCH MUX INPUT STUCK - DDM When Monitored: Continuously. Set Condition: If the voltage on the Driver Rear Window Switch Mux circuit is between 0.6 and 4.4 volts for over 15 seconds, this code will set. POSSIBLE CAUSES DTC PRESENT REAR SWITCH DRIVER REAR WINDOW SWITCH MUX CIRCUIT PARTIAL SHORT TO GROUND. DRIVER DOOR MODULE TEST ACTION APPLICABILITY 1 Turn the ignition on. t, erase DTCs. Cycle the ignition switch from Off to Run. t, read DTCs. Does the DRBIII t display DRIVER REAR WINDOW SWITCH MUX CIRCUIT STUCK? All Yes → Go To 2 No → The condition that caused this code to set is not present at this time. Operate the rear switch several times to ensure it does not 2 Disconnect the Driver Rear Window Switch connector. t, erase DTCs. Cycle the ignition switch from Off to Run. t, read DTCs. Does the DRBIII t display DRIVER REAR WINDOW SWITCH MUX CIRCUIT STUCK? All Yes → Go To 3 No → Replace the Rear Window Switch. Perform BODY VERIFICATION TEST - VER 1. 1017 POWER WINDOWS |