TEST
ACTION
APPLICABILITY
4
Turn the ignition off.
Disconnect the Satellite Receiver Antenna connector.
Disconnect the Satellite Radio Receiver harness connectors.
Measure the resistance between ground and the Satellite Signal circuit.
Is the resistance below 5.0 ohms?
All
Yes
→ Repair the Satellite Signal circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 5
5
Turn the ignition off.
Check the antenna for physical damage.
Disconnect the Satellite Receiver Antenna connector.
Disconnect the Satellite Radio Receiver harness connectors.
NOTE: Check the related wiring terminals for corrosion, damage or termi-
nal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
Replace the Satellite Receiver Antenna in accordance with the service information.
Turn the ignition and the radio on and place the radio in Satellite mode.
Does the DTC return?
All
Yes
→ Go To 6
No
→ Repair is complete.
Perform BODY VERIFICATION TEST - VER 1.
6
NOTE: Disconnect the Satellite Radio Receiver harness connectors and
check the related wiring terminals for corrosion, damage or terminal push
out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Satellite Radio Receiver in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
285
AUDIO
ANTENNA NOT CONNECTED - SDARS —
Continued