|
|
(P0700) TRANSMISSION SLIPPING (CONTINUED) When Monitored and Set Condition • When Monitored: Engine RPM greater than 450 RPM, output speed greater than 180 RPM, no N2 - N3 input • Set Condition: Calculated ratio not within allowable range for the engaged gear. No shifting operation. The POSSIBLE CAUSES OTHER DTCS PRESENT AXLE - MECHANICAL - GEAR RATIO INTERNAL TRANSMISSION TRANSMISSION CONTROL MODULE For a complete Transmission Control Module Circuit Diagram, (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTO- Diagnostic Test 1. PRE-DIAGNOSTIC CHECK OUT Note: Low fluid level can be the cause of many transmission Note: Always perform diagnostics with a fully charged battery to T , read Engine DTCs. Check and repair all engine DTCs prior to performing transmission symptom diagnostics. With the DRB III T , read and record all Transmission DTCs. Note: Check connectors - Clean/repair as necessary. Poor pin to Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run. Note: Check for any Technical Service Bulletin that may apply. Perform this procedure prior to Symptom diagnosis. Continue Go To 2 ZH NAG1 - ELECTRICAL DIAGNOSTICS 21 - 73 |