|
|
BODY VERIFICATION TEST BODY VERIFICATION TEST 1. Turn the ignition off. Disconnect all jumper wires and reconnect all previously disconnected components and connectors. Note: If the SKREEM or the PCM was replaced, refer to the service information for proper programming Program all RKE transmitters and other options as necessary. With the DRB III T , erase all Diagnostic Trouble Codes (DTCs) from ALL modules. Start the engine and allow it to run for 2 minutes. Operate all functions of the system that caused the original complaint. Ensure that all accessories are turned off and the battery is fully charged. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRB III T , read DTCs from ALL modules. Are any DTCs present or is the original complaint still present? Are any DTCs present? YES >> Repair is not complete, refer to appropriate symptom. NO >> Repair is complete. ZH LAMPS/LIGHTING - EXTERIOR - ELECTRICAL DIAGNOSTICS 8L - 77 |