4. Connect the voltmeter (1) to measure between the
battery (2) negative cable terminal clamp and a
good clean ground on the engine block (3). Rotate
and hold the ignition switch in the Start position.
Observe the voltmeter (1). If the reading is above
0.2 volt, clean and tighten the battery (2) negative
cable eyelet terminal connection to the engine
block. Repeat the test. If the reading is still above
0.2 volt, replace the faulty battery negative cable.
TRAY
DESCRIPTION
DESCRIPTION
The battery is mounted in a battery tray (1) located in
the right rear corner of the engine compartment. The
battery tray and support unit is secured at the front
with a bolt (2) on the front wheelhouse inner panel,
and at the rear with a bolt (2) on a bracket from the
bulkhead.
ZH
BATTERY SYSTEM
8F - 23