|
|
Content .. 2290 2291 2292 2293 ..
in rubber insulators that are held by clamps to the frame side rails. The ends of the stabilizer shaft The upper ball joint assembly is integrated into the upper control arm. The assembly attaches to The lower ball joint assembly is integrated into the control arm. The assembly attaches to the The upper and the lower control arms have pressed-in bushings. The bolts pass through the Ball joint assemblies have rubber grease seals. These seals prevent the entry of moisture and dirt. Four-wheel drive models have a front suspension that consists of the following components: Control arms Stabilizer shaft Shock module/Shock absorbers Coil Springs (1500 series) Torsion bars (2500, 3500 series) The upper part of each shock absorber (2500, 3500 series) extends through a frame bracket. Two The upper part of each shock module (1500 series) attaches to the frame by 3 nuts. The lower A spring steel stabilizer shaft controls the side roll of the front suspension. This shaft is mounted The front end of the torsion bar attaches to the lower control arm. The rear of the torsion bar Both RWD and 4WD models have sealed front wheel bearings. These bearings are pre-adjusted
2008 Chevrolet Silverado 1500 2008 SUSPENSION Front Suspension - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
SPECIAL TOOLS AND EQUIPMENT SPECIAL TOOLS Illustration Tool Number/ Description J-24319-B Steering Linkage and Tie Rod Puller J-36202 Torsion Loading/Unloading Tool J-36660-A Torque Angle Meter
2008 Chevrolet Silverado 1500 2008 SUSPENSION Front Suspension - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
J-42188-B Ball Joint Separator J-43631 Ball Joint Remover J-45400 Strut Spring Compressor
2008 Chevrolet Silverado 1500 2008 SUSPENSION Front Suspension - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|
|
|