|
|
REMOVAL/INSTALLATION OF SOUND SYSTEM The sound system includes sound source, speaker and antenna. The sound source includes
1. INSTALLATION OF THE RECORDER ASSEMBLY z Disconnect the negative grid of the battery. z Install the hardware frame into the sub-instrument frame, and using a flat screwdriver to open the top, bottom, left and right locking plates of the frame; z Connect the power supply wire, control wires, signal and antenna wires at the back portion z Push the playing machine into the mounting frame evenly with your thumbs and forefingers resting on the left and right of the control panel, till you hear the sound of the
2. INSTALLATION OF ANTENNA z Disconnect the negative grid of the battery. z Install the antenna on the installation hole and align it with the vehicle body; z Fasten it with washers and non-standard nuts, and connect the conducting wires properly; z Place the front end of the antenna wiring harness until it reaches the rear of the recorder, and plug the rear end of the antenna wiring harness into the socket of the antenna; z Bind the antenna wiring harness along the interior left-hand wiring harness.
3. INATALLATION OF FRONT SPEAKER z Disconnect the negative grid of the battery. z Connect the connectors of the wiring harness. z Place the wiring connection of speaker into installation hole towards the left and fasten it by turning it towards the right side (note: the connection terminals must face the indoor z Align it at the correct direction and press the speaker cover into it.
4. INSTALLATION OF FRONT DOOR SPEAKER z Connect the wiring harness properly, and place the speaker plugs upside down into the speaker mounting position of the door protection guard. After that, mount the speaker z Fasten 4 self-tapping screws;
T-73 |