Acura TSX / Honda Accord CL. Manual - part 472

Fig. 264: Installing The Harness Holder, Bracket & Clamp 

6. Reconnect the MAP sensor and throttle actuator connectors.  

7. Install the evaporative emission (EVAP) canister hose (A) and brake booster vacuum hose (B). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 265: Installing The Hoses 

8. Install the intake manifold cover. 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 266: Installing The Intake Manifold Cover 

9. Install the intake air duct (A), then connect the intake air temperature (IAT) sensor connector (B), and 

install the vacuum hose (C) and breather pipe (D). 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX

  

 

Fig. 267: Installing The Intake Air Duct 

10. Clean up any spilled engine coolant.  

11. After installation, check that all tubes, hoses and connectors are installed correctly.  

12. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open 

(see COOLANT REPLACEMENT ).  

EXHAUST MANIFOLD REMOVAL & INSTALLATION 

1. Remove the VTEC solenoid valve (see REMOVAL & INSTALLATION ).  

2. Remove the cover and exhaust manifold bracket, then remove the exhaust manifold. 

 

2004 Acura TSX 

2004 ENGINES 2.4L DOHC VTEC - TSX