|
|
Lotus Service Notes Section WD Page 19 Removal of Seat Belt Assembly WARNING: Before removing or refitting a pyrotechnic seat belt assembly, the ignition key should be Each seat belt reel assembly is secured, via a spacer block, to the seat belt mounting bracket/roof hoop by a single bolt. Note that an orientation tang is incorporated on the belt reel which engages with a hole in the 1. Check that the key is removed from the ignition switch. 2. Disconnect both battery cables, and insulate to ensure that accidental contact cannot occur. 3. Remove both seats by releasing the seat belt from the seat (noting the 10mm spacer), and the seat 4. Remove the centre tunnel rear cup holder liner after removing the single screw from inside the base. 5. Remove the 4 fixings along the top of the cabin rear bulkhead trim panel, and withdraw the panel, 6. Hinge up the plastic cover and release the belt slide from the roof hoop, noting the 5mm spacer. 7. Allow at least one minute from disconnecting the battery before disconnecting the electrical connector Fitment of Seat Belt Assembly WARNING: Before removing or refitting a pyrotechnic seat belt assembly, the ignition key should be Each seat belt reel assembly is secured, via a spacer block, to the seat belt mounting bracket/roof hoop by a single bolt. Note that an orientation tang is incorporated on the belt reel which engages with a hole in the 1. Fit the seat belt reel assembly and alloy spacer to the bracket on the mounting frame, with the spacer block located by its roll pin into the hole in the bracket, and the belt reel tang located in the upper hole in 2. Fit the belt slide to the roof hoop with the 5mm spacer interposed, and tighten the special shouldered bolt to 45 Nm (33 lbf.ft). Check that the hoop is free to pivot. Clip the plastic cover into position. 3. Refit the cabin rear bulkhead trim panel, connecting the interior lamp and speakers, and retain with the four screws. 4. Refit the cup holder, connecting the power socket, and liner. 5. Refit the seats and fit the seat belt to the seat frame with the 10mm spacer between belt and seat. Tighten the special shouldered bolt to 33 Nm (24 lbf.ft). Check that the belt eye is free to pivot. 6. Reconnect the battery, turn on the ignition, and check that the airbag tell tale lamp lights for a few seconds and then goes out. |