Porshe 911 (997). Manual - part 929

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  927  928  929  930   ..

 

 

Porshe 911 (997). Manual - part 929

 

 

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Installing outside temperature sensor

3873

- Preliminary work
- Removing control module for ParkAssist
- Installing control module for ParkAssist
- Subsequent work
- Programming control unit for ParkAssist

Tools

Designation

Type

Number

Explanation

PIWIS Tester

special tool

9718

Preliminary work

Preliminary work - control module for ParkAssist

→  21 Removing and installing front seat - removing

Removing control module for ParkAssist

Removing control module for ParkAssist

Note

If the ParkAssist control unit has to be replaced, the values from the control unit should first be read out using
the PIWIS Tester 9718. → 917419 Removing and installing ParkAssist control unit - chapter on
"Programming"

3874

Installation Location:

Installation position

Control unit holder.

1. Push control unit forwards in direction of travel from behind, unclip it, detach it and turn the holder 180°.

Diagnostic system: reading out fault memory and activating systems

Removing control module for ParkAssist

3875

Mounting point for control unit

2. Push together the retaining tabs for the control unit and pull the two catches back. Lift control unit up

and out.

Connector

WARNING

Risk of damage to electronic control modules.

If care is not taken, electrical and electronic components may be destroyed.

• 

→ Before removing the control module, switch off the ignition and remove the ignition key.

3. -A- Carefully lever the connector away from the control unit using two

screwdrivers.

4. -B- Carefully lever the connector away from the control unit using one screwdriver.

Diagnostic system: reading out fault memory and activating systems

Removing control module for ParkAssist

3876

 

 

 

 

 

 

 

Content   ..  927  928  929  930   ..