Porshe 911 (997). Manual - part 1012

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1010  1011  1012  1013   ..

 

 

Porshe 911 (997). Manual - part 1012

 

 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Installing cover of hand-held transmitter

4205

- Preliminary work
- Removing tilt sensor control unit
- Installing tilt sensor control unit
- Subsequent work

Preliminary work

Preliminary work

Remove centre console cover. →  21 Removing and installing centre console cover - chapter on "removing"

Removing tilt sensor control unit

Removing tilt sensor control unit

Note

The tilt sensor is integrated into the tilt control unit and cannot be separately replaced.

• 

Installation Location:

4206

Overview of tilt sensor control unit

WARNING

Risk of damage to electronic control modules.

If care is not taken, electrical and electronic components may be destroyed.

• 

→ Before removing the control module, switch off the ignition and remove the ignition key.

1. Switch off ignition and remove ignition key.

Unscrewing fastening screws for tilt sensor conrol unit

2. Unscrew the two fastening nuts -1- and remove the tilt sensor conrol unit.

3. Remove the two sheetmetal nuts -2- from the tilt sensor conrol

unit.

Diagnostic system: reading out fault memory and activating systems

Removing tilt sensor control unit

4207

Removing plug for tilt sensor control unit

4. Unlock plug for tilt sensor control unit -Arrow a- and

remove.

Installing tilt sensor control unit

Installing tilt sensor control unit

Connect plug to tilt sensor control unit.

1. Push plug onto tilt sensor control unit until it is felt to

engage.

Tightening fastening screws for tilt sensor conrol unit

Diagnostic system: reading out fault memory and activating systems

 Installing tilt sensor control unit

4208

 

 

 

 

 

 

 

Content   ..  1010  1011  1012  1013   ..