|
|
DIAGNOSIS SENSOR UNIT SR-53 < REMOVAL AND INSTALLATION > [FOR MEXICO] C D E F G I J K L M A B SR N O P DIAGNOSIS SENSOR UNIT Exploded View INFOID:0000000008457600 Removal and Installation INFOID:0000000008457601 WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more. • Before disconnecting the air bag sensor unit harness connector, be sure to disconnect the each har- ness connector of the air bag module and pre-tensioner seat belt to prevent air bag deployment by • Never use the air tools or electric tools for servicing. est parts information. Installing an incorrect air bag diagnosis sensor unit may or may not cause the REMOVAL 1. Always check the air bag diagnosis sensor unit ECU discriminated number (identification number) using 2. Disconnect the each connector of all air bag modules and pre-tensioner seat belts. 3. Remove the instrument lower cover (LH and RH). Refer to . 4. Remove the rear foot duct 1 (LH and RH). Refer to VTL-125, "REAR FOOT DUCT 1 : Exploded View" . 5. Remove the instrument stay LH. Refer to 6. Remove the front console bracket. Refer to 7. Disconnect the diagnosis sensor unit harness connectors. 8. Remove the fixing bolts, ground bolt, and then remove the diagnosis sensor unit. CAUTION: 1. Diagnosis sensor unit A. Diagnosis sensor unit harness connector B. Ground bolt : Do not reuse : N·m (kg-m, ft-lb) JMHIA0517GB Revision: 2012 September 2013 MURANO |