|
|
REAR DRIVE SHAFT RAX-15 < REMOVAL AND INSTALLATION > [AWD] C E F G H I J K L M A B RAX N O P REAR DRIVE SHAFT Exploded View INFOID:0000000007542436 Removal and Installation INFOID:0000000007542437 REMOVAL 1. Remove tires with power tool. 2. Remove wheel sensor and sensor harness. Refer to BRC-122, "REAR WHEEL SENSOR : Exploded . 3. Remove caliper assembly. Hang caliper assembly not to interfere with work. Refer to CALIPER ASSEMBLY : Exploded View" . CAUTION: Never depress brake pedal while caliper assembly is removed. 4. Remove disc rotor. Refer to BR-48, "BRAKE CALIPER ASSEMBLY : Removal and Installation" . 5. Remove cotter pin, then loosen wheel hub lock nut with power tool. Refer to . 6. Patch wheel hub lock nut with a piece of wood. Hammer the wood to disengage wheel hub and bearing CAUTION: • Never place drive shaft joint at an extreme angle. Also be careful not to overextend slide joint. and the other parts. NOTE: 7. Remove the wheel hub lock nut. Refer to 8. Remove wheel hub and bearing assembly. Refer to 9. Remove hub cap. Refer to . 1. Circular clip 2. Dust shield 3. Housing 4. Snap ring 5. Spider assembly 6. Boot band 7. Boot 8. Shaft 9. Circular clip 10. Joint sub-assembly : Wheel side : Fill NISSAN genuine grease or an equivalent. Refer to for symbols not described on the above. JPDIG0098GB Revision: 2013 February 2012 MURANO |