|
|
MIR-12 < DTC/CIRCUIT DIAGNOSIS > [WITH ADP] DOOR MIRROR REMOTE CONTROL SWITCH 4. Check continuity between automatic drive positioner control unit harness connector and ground. Is the inspection result normal? YES >> Replace automatic drive positioner control unit. Refer to ADP-182, "Removal and Installation" NO >> Repair or replace harness. 3. CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT 1. Turn ignition switch OFF. 2. Check continuity between door mirror remote control switch harness connector and ground. Is the inspection result normal? YES >> GO TO 4. NO >> Repair or replace harness. 4. CHECK MIRROR SWITCH Check door mirror remote control switch (mirror switch). MIR-12, "MIRROR SWITCH : Component Inspection" Is the inspection result normal? YES >> GO TO 5. NO >> Replace door mirror remote control switch (mirror switch). Refer to . 5. CHECK INTERMITTENT INCIDENT Check intermittent incident. GI-44, "Intermittent Incident" >> INSPECTION END MIRROR SWITCH : Component Inspection INFOID:0000000007540662 1. CHECK MIRROR SWITCH 1. Turn ignition switch OFF. 2. Disconnect door mirror remote control switch connector. 3. Check continuity between door mirror remote control switch terminals. Automatic drive positioner control unit Door mirror remote control switch Continuity Connector Terminal Connector Terminal M75 3 D14 15 Existed 4 13 15 12 16 4 Automatic drive positioner control unit Ground Continuity Connector Terminal M75 3 Not existed 4 15 16 Door mirror remote control switch Ground Continuity Connector Terminal D14 7 Existed Revision: 2013 February 2012 MURANO |