|
|
GW-20 < REMOVAL AND INSTALLATION > FRONT DOOR GLASS 1. Fully open the door glass. 2. Place a wooden piece (wooden hammer handle, etc.) at near fully closed position. 3. Perform fully closing operation with auto up switch. • Check that the glass reverses without pinching the wooden piece, is lowered approximately 150 mm (5.906 in) or for more than 3 seconds and then stops. • The glass should not be raised with power window main switch operated while it is reversing or lowering. CAUTION: • Be careful not to be pinched. FITTING INSPECTION • Check that the glass is fit securely into the sash groove. sash is parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail Revision: 2013 February 2012 MURANO |