|
|
FRONT WHEEL HUB AND KNUCKLE FAX-11 < REMOVAL AND INSTALLATION > [2WD] C E F G H I J K L M A B FAX N O P 11. Temporarily tighten strut assembly and steering knuckle. 12. Remove wheel hub and bearing assembly, and then remove splash guard. . 14. Remove steering knuckle from transverse link. 15. Remove steering knuckle from strut assembly. INSTALLATION Note the following, and install in the reverse order of the removal. CAUTION: Never apply lubricating oil to these matching surface. • Clean the matching surface of drive shaft and wheel hub and bearing assembly. CAUTION: Apply paste [service parts (440037S000)] to cover entire flat • Never use a power tool to tighten the wheel hub lock nut. tions, which were removed when removing wheel hub and bearing • Never reuse cotter pin. Inspection INFOID:0000000007541198 INSPECTION AFTER REMOVAL Check components for deformation, cracks, and other damage. Replace if necessary. Ball Joint Inspection Check boots of transverse link and steering outer socket ball joint for breakage, axial play, and torque. Refer to INSPECTION AFTER INSTALLATION 1. Check wheel sensor harness for proper connection. Refer to BRC-121, "FRONT WHEEL SENSOR : . 2. Check the wheel alignment. Refer to . 3. Adjust neutral position of steering angle sensor. Refer to BRC-9, "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement" . Amount paste : 1.0 – 3.0 g (0.04 – 0.10 oz) JPDIG0122ZZ Revision: 2013 February 2012 MURANO |