|
|
TROUBLE DIAGNOSIS TF-23 C E F G H I J K L M A B TF Revision: 2006 August 2006 Murano AWD Control Unit Input/Output Signal Reference Values NDS0007E AWD CONTROL UNIT INSPECTION TABLE Monitored item [Unit] Content Condition Display value FR RH SENSOR [km/h] or [mph] Wheel speed (Front wheel Vehicle stopped 0.00 km/h (0.00 mph) Vehicle running CAUTION: Check air pressure of tire under Approximately equal to ± 10%) FR LH SENSOR [km/h] or [mph] Wheel speed (Front wheel Vehicle stopped 0.00 km/h (0.00 mph) Vehicle running CAUTION: Check air pressure of tire under Approximately equal to ± 10%) RR RH SENSOR [km/h] or [mph] Wheel speed (Rear wheel Vehicle stopped 0.00 km/h (0.00 mph) Vehicle running CAUTION: Check air pressure of tire under Approximately equal to ± 10%) RR LH SENSOR [km/h] or [mph] Wheel speed (Rear wheel Vehicle stopped 0.00 km/h (0.00 mph) Vehicle running CAUTION: Check air pressure of tire under Approximately equal to ± 10%) BATTERY VOLT [V] Power supply voltage for Ignition switch: ON Battery voltage THRTL POS SEN [%] Throttle opening condition When depressing accelerator pedal 0 - 100% ETS SOLENOID [A] Monitored value of current at Engine speed AUTO Approx. 0.000A LOCK Approx. 0.000A Engine speed AUTO Approx. 0.000 - 0.500A* LOCK Approx. 1.800A STOP LAMP SW [ON/OFF] Condition of brake pedal Brake pedal: Depressed ON Brake pedal: Released OFF ENG SPEED SIG [RUN/STOP] Condition of engine running Engine stopped STOP Engine running RUN ETS ACTUATOR [ON/OFF] Operating condition of AWD Engine stopped (Ignition OFF Engine running ON 4WD WARN LAMP [ON/OFF] AWD warning lamp condition AWD warning lamp: ON ON AWD warning lamp: OFF OFF 4WD MODE SW [ON/OFF] Input condition from AWD lock AWD lock switch OFF OFF ON ON 4WD MODE MON [AUTO/LOCK] Control status of AWD AWD LOCK indicator OFF AUTO ON LOCK |