|
|
REAR DRIVE SHAFT RAX-11 C E F G H I J K L M A B RAX Revision: 2005 August 2005 Murano CAUTION: If there is grease on boot mounting surfaces (indicated by* 8. Make sure boot installation length “L” is the length indicated CAUTION: ● Boot may break if boot installation length is less than ● Take care not to touch the tip of screwdriver to inside of boot. 9. Secure big and small ends of boot with new boot bands as CAUTION: Discard old boot bands; replace with new ones. 10. After installing housing and shaft, rotate boot to check whether or not the actual position is correct. If boot position is not correct, Wheel Side 1. Insert the amount of new grease (NISSAN genuine grease or 2. Wind serrated part of shaft with tape. Install new boot band and CAUTION: Discard old boot band and boot; replace with new ones. 3. Remove protective tape wound around serrated part of shaft. Boot installation length “L : 78.6 - 80.6 mm SDIA1126E SFA395 SDIA1127E SFA800 |