Nissan Murano Z50 (2005 year). Manual

SERVICE DATA AND SPECIFICATIONS (SDS)

ATC-153

ATC

Revision: 2005 August

2005 Murano

SERVICE DATA AND SPECIFICATIONS (SDS)

PFP:00030

Compressor

AJS0010N

Lubricant

AJS0010O

Refrigerant

AJS0010P

Engine Idling Speed

AJS0010Q

Refer to

EC-75, "Idle Speed and Ignition Timing Check"

Belt Tension

AJS0010R

Refer to

EM-13, "DRIVE BELTS"

Model

ZEXEL VALEO CLIMATE CONTROL make DKS-17D

Type

Swash plate

Displacement

(cu in)/rev

175 (10.7)

Cylinder bore

stroke

mm (in)

30.5 (1.20)

24.0 (0.94)

Direction of rotation

Clockwise (viewed from drive end)

Drive belt

Poly V

Model

ZEXEL VALEO CLIMATE CONTROL make DKS-17D

Name

Nissan A/C System Oil Type S (DH-PS)

Part number

KLH00-PAGS1P

Capacity

(US fl oz, lmp fl oz)

Total in system

150 (5.03, 5.3)

Compressor (Service part) charging
amount

150 (5.03, 5.3)

Type

HFC-134a (R-134a)

Capacity
kg (lb)

0.525 (1.16)

PRECAUTIONS

AV-5

Revision: 2005 August

2005 Murano

PRECAUTIONS

PFP:00001

Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”

AKS007WC

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.

WARNING:

●

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.

●

Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.

●

Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.

AUDIO

AV-7

Revision: 2005 August

2005 Murano

AUDIO

PFP:28111

System Description

AKS005EV

BASE SYSTEM

For Audio System operation information, refer to Owner's Manual.
Power is supplied at all times

●

through 15A fuse [No. 38, located in the fuse and fusible link block]

●

to audio unit terminal 6

●

to display unit terminal 1

●

to A/C and AV switch terminal 1

●

to option connector for satellite radio receiver terminal 22

●

to option connector for DVD terminal 1.

With the ignition switch in the ACC or ON position, power is supplied

●

through 10A fuse [No. 6, located in the fuse block (J/B)]

●

to audio unit terminal 10

●

to display unit terminal 2

●

to A/C and AV switch terminal 2

●

to option connector for satellite radio receiver terminal 26

●

to option connector for DVD terminal 2.

Ground is supplied through the case of the audio unit.
Audio unit and A/C and AV switch are connected by FPC (Flexible Print Circuit).
A/C and audio controller integrates A/C switches and audio switches.
When A/C and audio controller is pressed to audio switch, it sends audio signal to audio unit.
Then audio signals are supplied

●

through audio unit terminals 1, 2, 3, 4, 13, 14, 15, and 16

●

to terminals 1 and 2 of front door speaker LH and RH

●

to terminals 1 and 2 of rear door speaker LH and RH

●

to terminals 1 and 2 of tweeter LH and RH.

When one of audio steering wheel switch is pressed to volume up, seek up, or mode ON, resistance in audio
steering wheel switch circuit changes depending on which button is pressed.
When one of audio steering wheel switch is pressed to volume down, seek down, or power ON, resistance in
audio steering wheel switch circuit changes depending on which button is pressed.

BOSE SYSTEM

For Audio System operation information, refer to Owner's Manual.
Power is supplied at all times

●

through 15A fuse [No. 38, located in the fuse and fusible link block]

●

to audio unit terminal 6

●

to BOSE speaker amp. terminal 1

●

to A/C and AV switch terminal 1

●

to display control unit terminal 1 (with navigation system)

●

to display unit terminal 1 (without navigation system)

●

to option connector for satellite radio receiver terminal 22

●

to option connector for DVD terminal 1.

With the ignition switch in the ACC or ON position, power is supplied

●

through 10A fuse [No. 6, located in the fuse block (J/B)]

●

to audio unit terminal 10

●

to A/C and AV switch terminal 2

●

to display control unit terminal 10 (with navigation system)

●

to display unit terminal 2 (without navigation system)

●

to option connector for satellite radio receiver terminal 26

●

to option connector for DVD terminal 2.

AV-8

AUDIO

Revision: 2005 August

2005 Murano

Ground is supplied through the case of the audio unit.
Ground is also supplied

●

to BOSE speaker amp. terminal 17

●

through body ground B105 and B116,

●

to A/C and AV switch terminal 5

●

to display control unit terminal 3 (with navigation system)

●

to display terminal 1 (with navigation system)

●

to display unit terminal 6 (without navigation system)

●

to option connector for DVD terminal 3

●

through body ground M14 and M78.

Audio unit and A/C and AV switch are connected by FPC (Flexible Print Circuit).
A/C and audio controller integrates A/C switches and audio switches.
When A/C and audio controller is pressed to audio switch, it send audio signal to audio unit.
Then audio signals are supplied

●

through audio unit terminals 1, 2, 3, 4, 13, 14, 15, and 16

●

to BOSE speaker amp. terminals 23, 24, 25, 26, 27, 28, 29, and 30.

Audio signals are amplified by the BOSE speaker amp.
The amplified audio signals are supplied

●

through BOSE speaker amp. terminals 2, 3, 9,10,11,12, 13, 14, 15, 16, 18, and 19

●

to terminals 1 and 2 of front door speaker LH and RH

●

to terminals 1 and 2 of rear door speaker LH and RH

●

to terminals 1 and 2 of tweeter LH and RH

●

to terminals 2, 3, 4 and 6 of woofer.

SPEED SENSITIVE VOLUME SYSTEM

Volume level of this system gone up and down automatically in proportion to the vehicle speed. And the con-
trol level can be selected by the customer. This system is equipped for BOSE system.

Nissan Murano Z50 (2005 year). Manual - part 12