|
|
TROUBLE DIAGNOSIS EC-111 C D E F G H I J K L M A EC Revision: 2004 November 2004 Murano THRTL SEN 1 [V] × × ● The throttle position sensor signal volt- ● THRTL SEN2 signal is converteds by THRTL SEN 2 [V] × FUEL T/TEMP SE [ ° C] or [ ° F] × ● The fuel temperature (determined by INT/A TEMP SE [ ° C] or [ ° F] × × ● The intake air temperature (determined EVAP SYS PRES [V] × ● The signal voltage of EVAP control sys- FUEL LEVEL SE [V] × ● The signal voltage of the fuel level sen- START SIGNAL [ON/ × × ● Indicates start signal status [ON/OFF] ● After starting the engine, [OFF] is dis- CLSD THL POS [ON/ × × ● Indicates idle position [ON/OFF] com- AIR COND SIG [ON/ × × ● Indicates [ON/OFF] condition of the air P/N POSI SW × × ● Indicates [ON/OFF] condition from the PW/ST SIGNAL [ON/ × × ● [ON/OFF] condition of the power steer- LOAD SIGNAL [ON/ × × ● Indicates [ON/OFF] condition from the IGNITION SW × ● Indicates [ON/OFF] condition from igni- HEATER FAN SW ● Indicates [ON/OFF] condition from BRAKE SW ● Indicates [ON/OFF] condition from the INJ PULSE-B1 [msec] × ● Indicates the actual fuel injection pulse ● When the engine is stopped, a certain INJ PULSE-B2 [msec] IGN TIMING [BTDC] × ● Indicates the ignition timing computed ● When the engine is stopped, a certain CAL/LD VALUE [%] ● “Calculated load value” indicates the Monitored item [Unit] ECM INPUT SIG- NALS MAIN SIG- NALS Description Remarks |