|
|
BCM (BODY CONTROL MODULE) WW-91 < ECU DIAGNOSIS > C D E F G H I J K M A B WW N O P Display contents of CONSULT Fail-safe Cancellation B2013: ID DISCORD BCM-S/L Inhibit engine cranking Erase DTC B2014: CHAIN OF S/L-BCM Inhibit engine cranking Erase DTC B2190: NATS ANTENNA AMP Inhibit engine cranking Erase DTC B2191: DIFFERENCE OF KEY Inhibit engine cranking Erase DTC B2192: ID DISCORD BCM-ECM Inhibit engine cranking Erase DTC B2193: CHAIN OF BCM-ECM Inhibit engine cranking Erase DTC B2195: ANTI SCANNING Inhibit engine cranking Ignition switch ON → OFF B2557: VEHICLE SPEED Inhibit steering lock When normal vehicle speed signals are received from ABS actua- B2560: STARTER CONT RELAY Inhibit engine cranking 500 ms after the following CAN signal communication status be- B2601: SHIFT POSITION Inhibit steering lock 500 ms after the following signal reception status becomes consis- B2602: SHIFT POSITION Inhibit steering lock 5 seconds after the following BCM recognition conditions are ful- voltage) • Vehicle speed: 4 km/h (2.5 MPH) or more B2603: SHIFT POSI STATUS Inhibit steering lock 500 ms after the following BCM recognition conditions are fulfilled voltage) • Selector lever P/N position signal: Except P and N positions (0 V) B2604: PNP SW Inhibit steering lock 500 ms after any of the following BCM recognition conditions are age) - P range signal or N range signal (CAN): ON B2605: PNP SW Inhibit steering lock 500 ms after any of the following BCM recognition conditions are age) - PNP switch signal (CAN): ON B2606: S/L RELAY Inhibit engine cranking 500 ms after the following CAN signal communication status be- Revision: 2008 October 2009 Murano |