|
|
P1572 ICC BRAKE SWITCH EC-429 < DTC/CIRCUIT DIAGNOSIS > [VQ35HR] C D E F G H I J K L M A EC N P O Is 1st trip DTC detected? YES >> Go to NO >> GO TO 3. 3. PERFORM DTC CONFIRMATION PROCEDURE-II 1. Drive the vehicle for at least 5 consecutive seconds under the following conditions. CAUTION: Always drive vehicle at a safe speed. 2. Check 1st trip DTC. Is 1st trip DTC detected? YES >> Go to NO >> INSPECTION END Diagnosis Procedure INFOID:0000000005237037 1. CHECK OVERALL FUNCTION-I With CONSULT-III 1. Turn ignition switch ON. 2. Select “BRAKE SW1” in “DATA MONITOR” mode with CONSULT-III. 3. Check “BRAKE SW1” indication under the following conditions. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector terminals under the following conditions. Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 3. 2. CHECK OVERALL FUNCTION-II With CONSULT-III Select “BRAKE SW2” and check indication under the following conditions. VHCL SPEED SE More than 30 km/h (19 mph) Selector lever Suitable position Driving location Depress the brake pedal for more than 5 seconds so as Monitor item Condition Indication BRAKE SW1 Brake pedal Slightly depressed OFF Fully released ON ECM Condition Voltage (V) Connector + – Terminal Terminal M107 126 (ICC brake switch signal) 128 Brake pedal Slightly depressed Approx. 0 Fully released Battery voltage Monitor item Condition Indication BRAKE SW2 Brake pedal Slightly depressed ON Fully released OFF |