|
|
HOOD DLK-239 < REMOVAL AND INSTALLATION > C D E F G H I J L M A B DLK N O P Unit: mm (in) 1. Remove striker and adjust the surface height of hood, front bumper fascia and front fender according to 2. Adjust the height difference of striker, hood bumper rubber according to the fitting standard dimension. 3. Loosen hood hinge mounting nuts on the hood. 4. Adjust the clearance of hood, front bumper fascia and front fender according to the fitting standard dimen- 5. Check that hood lock primary latch is securely engaged with striker by dropping hood from approximately CAUTION: Never drop hood from a height of 300 mm (11.811 in) or more. 6. Install as static closing face of hood is 94 – 490 N (9.6 – 50.0 kg, 21.1 – 110 lb). 7. After adjustment, tighten hood hinge mounting nuts to the specified torque. CAUTION: • Before installing hood hinge, apply anticorrosive agent onto the mounting surface of the vehicle body. • Check hood hinge rotating part for poor lubrication. If necessary, apply body grease. and nuts. HOOD HINGE Portion Standard Difference (LH/RH, MAX) Hood – Front bumper A – A D Clearance 2.6 – 5.6 (0.102 – 0.220) — E Surface height − 2.0 – 0.5 ( − 0.079 – 0.020) — Hood – Front fender B – B F Clearance 2.5 – 4.5 (0.098 – 0.177) 2.0 (0.079) G Surface height − .0 – 0.0 ( − 0.118 – 0.000) — C – C H Surface height − 1.0 – 1.0 ( − 0.039 – 0.039) — Hood striker – Bumper — I Height difference 32.3 – 33.3 (1.272 – 1.311) — |