Infiniti FX35, FX50 (S51). Manual - part 407
CCS-448
< BASIC INSPECTION >
[LDW & LDP]
INSPECTION AND ADJUSTMENT
1.
CHECK VEHICLE HEIGHT
Measure the wheelarch height. Calculate “Dh”.
NOTE:
“Dh” may be calculated as a minus value.
>> GO TO 2.
2.
CAMERA AIMING ADJUSTMENT
CONSULT-III WORK SUPPORT
CAUTION:
Operate CONSULT-III outside the vehicle, and close all the doors. (To retain vehicle attitude appropri-
ately)
1.
Select “Work Support” on “LANE CAMERA” with CONSULT-III.
2.
Select “AUTO AIM”.
3.
Confirm the following items;
-
The target should be accurately placed.
-
The vehicle should be stopped.
4.
Select “Start” to perform camera aiming.
CAUTION:
Never select “Start” when the target is not accurately placed.
5.
Input “Dh”, and then select “Start”.
CAUTION:
Never change “Ht” and “Dt”.
6.
Confirm the displayed item.
-
“Normally Completed”: Select “Completion”.
-
“SUSPENSION” or “ABNORMALLY COMPLETED”: Perform the following services.
NOTE:
Replace camera unit if “SUSPENSION” is repeatedly indicated during the above two services are performed.
7.
Confirm that “Normally Completed” is displayed and then select “End” to close the aiming adjustment pro-
cedure.
>> GO TO 3.
3.
PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of lane camera unit with CONSULT-III.
Is any DTC detected?
Dh [mm] = (Hfl + Hfr)
÷
2
−
831
where,
Hfl: Front left wheelarch height [mm]
Hfr: Front right wheelarch height [mm]
JPOIA0174ZZ
Displayed item
Possible cause
Service procedure
SUSPENSION
00H Routine not activated
• A target is not-yet-placed.
(The lane camera unit cannot detect
a target.)
• Lane camera unit malfunction.
Position the target appropriately
again. Perform the aiming
again. Refer to
"CAMERA AIMING ADJUST-
MENT : Special Repair Require-
ment (Target Setting)"
10H Writing error
• Temporary malfunction in internal
processing of the lane camera unit.
• Lane camera unit malfunction.
ABNORMALLY COMPLETED
—
• The position of the target is not cor-
rect.
• The position of the lane camera unit
is not correct.
• Inappropriate work environment.
• Inappropriate vehicle condition.
Position the target appropriately
again. Perform the aiming
again. Refer to
"CAMERA AIMING ADJUST-
MENT : Special Repair Require-
ment (Preparation)"