Infiniti FX35, FX50 (S51). Manual - part 1603

 

  Index      Infiniti     Infiniti FX35, FX50 (S51) - service repair manual 2010 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1601  1602  1603  1604   ..

 

 

Infiniti FX35, FX50 (S51). Manual - part 1603

 

 

SBC-70

< PRECAUTION >

PRECAUTIONS

• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and

buckles show no damage and continue to operate properly).

• The seat belt was damaged in an accident. (i.e. torn webbing, bent retractor or guide).
• The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage

or distortion and repair as necessary before installing a new seat belt assembly.

• Anchor bolts are deformed or worn out.
• The seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in

which the air bags are deployed.

PRE-INSPECTION FOR DIAGNOSTIC

SBC-71

< PERIODIC MAINTENANCE >

C

D

E

F

G

I

J

K

L

M

A

B

SBC

N

O

P

PERIODIC MAINTENANCE

PRE-INSPECTION FOR DIAGNOSTIC

Description

INFOID:0000000005241787

WARNING:

• The following tests should be performed in a safe, open place that is free of traffic and obstacles.
• The tests should be performed on a dry, paved road. Never attempt to perform the tests on a wet or

unpaved road, open road, or highway. (This may cause an accident or personal injury.)

• Driver and passenger should assume seat belt may operate and prepare themselves accordingly.

1.

Fasten driver and passenger seat belts.

2.

Drive at approximately 25 km/h (16 MPH).

3.

Notify passenger of a sudden stop. Driver and passenger prepare themselves for the possibility of system
not operating. Then, driver fully depresses the brake pedal to stop suddenly.

4.

Check that the shoulder of the seat belt is pulled while braking.

SBC-72

< PERIODIC MAINTENANCE >

BRAKE PEDAL STROKE SENSOR

BRAKE PEDAL STROKE SENSOR

Exploded View

INFOID:0000000005241788

Removal and Installation

INFOID:0000000005241789

REMOVAL

1.

Remove the instrument panel lower cover LH. Refer to 

IP-12, "Removal and Installation"

.

2.

Disconnect the brake pedal stroke sensor connector.

3.

Remove the screws (A).

4.

Remove the brake pedal stroke sensor (1).

INSTALLATION

Install in the reverse order of removal.

1.

Brake pedal stroke sensor 

JMHIA0712ZZ

JMHIA0726ZZ

PRE-CRASH SEAT BELT CONTROL UNIT

SBC-73

< PERIODIC MAINTENANCE >

C

D

E

F

G

I

J

K

L

M

A

B

SBC

N

O

P

PRE-CRASH SEAT BELT CONTROL UNIT

Exploded View

INFOID:0000000005241790

Refer to 

SB-6, "SEAT BELT RETRACTOR : Exploded View"

.

Removal and Installation

INFOID:0000000005241791

For removal and installation procedures, refer to 

SB-6, "SEAT BELT RETRACTOR : Removal and Installa-

tion"

.

 

 

 

 

 

 

 

Content   ..  1601  1602  1603  1604   ..