Content .. 1082 1083 1084 1085 ..
Infiniti FX35, FX50 (S51). Manual - part 1084
FAX-34
< REMOVAL AND INSTALLATION >
[AWD]
FRONT DRIVE SHAFT
a.
For one-touch clamp band. (Left side)
i.
Install boot bands securely as shown in the figure.
b.
For low profile type band. (Right side)
i.
Put boot band in the groove on drive shaft boot. Then fit pawls
(
) into holes to temporary installation.
NOTE:
For the large diameter side, fit projection (A) and guide slit (B) at
first.
ii.
Pinch projection on the band with suitable pliers to tighten band.
iii.
Insert tip of band below end of the pawl.
14. Secure housing and shaft, and then make sure that they are in
the correct position when rotating boot. Install them with boot
band when the mounting positions become incorrect.
15. Install dust shield to housing. (right side)
CAUTION:
Never reuse dust cover.
Inspection
INFOID:0000000005248999
INSPECTION AFTER REMOVAL
• Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for signifi-
cant looseness.
• Check boot for cracks, damage, and leakage of grease.
• Disassemble drive shaft and exchange malfunctioning part if there
is a non-standard condition.
INSPECTION AFTER DISASSEMBLY
Shaft
Check shaft for runout, cracks, or other damage. Replace it if necessary.
Joint Sub-Assembly (Wheel Side)
PDIA1188J
SDIA3557E
SDIA3558E
SDIA1163J