|
|
2. Install the new O-ring (A) on the new countershaft speed sensor (B), then install the countershaft speed sensor in the transmission housing. 3. Check the connector for rust, dirt, or oil, and clean if necessary, then connect the connector securely. 2ND CLUTCH TRANSMISSION FLUID PRESSURE SWITCH REPLACEMENT 1. Remove the intake air duct. 2. Disconnect the connector from the 2nd clutch transmission fluid pressure switch (A), and remove the switch. Fig. 242: Removing 2nd Clutch Transmission Fluid Pressure Switch 3. Make sure there is no water, oil, dust, or foreign particles inside the connector. 4. Install the new 2nd clutch transmission fluid pressure switch with a new sealing washer (B), and tighten
2004 Acura TSX 2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
|