Acura TSX / Honda Accord CL. Manual - part 812

 

  Index      Acura     Acura TSX 2004-2008 / Honda Accord CL 2006-2008 - service repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  810  811  812  813   ..

 

 

Acura TSX / Honda Accord CL. Manual - part 812

 

 

removed.  

14. Install the three dowel pins (A) and a new gasket (B) on the torque converter housing (C). 

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

Fig. 143: Installing The Three Dowel Pins And A New Gasket On The Torque Converter Housing

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

15. Align the spring pin (D) of the control shaft (E) with the transmission housing groove (F) by turning the 

control shaft. Do not squeeze the end of the control shaft tips together when turning the shaft. If the tips 
are squeezed together, it will cause a faulty shift position signal or position due to the play between the 
control shaft and the switch.  

16. Place the transmission housing (G) on the torque converter housing. Do not install the mainshaft and 

countershaft speed sensors before installing the transmission housing on the torque converter housing.  

17. While expanding the snap ring of the secondary shaft bearing using the snap ring pliers, push the 

transmission housing down to start the secondary shaft bearing through the snap ring. Then release the 
pliers, and push down the housing until it bottoms and snap ring snaps in place in the secondary shaft 
bearing snap ring groove. 

Fig. 144: Expanding The Snap Ring Of The Secondary Shaft Bearing Using The Snap Ring Pliers 

18. Verify that the secondary shaft bearing snap ring (A) is seated in the bearing and housing groove, and that 

the ring end gap (B) is correct. 

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

Fig. 145: Verifying That The Secondary Shaft Bearing Snap Ring Is Seated In The Bearing And 
Housing Groove, & That The Ring End Gap Is Correct
 

19. Install the transmission housing mounting bolts along with the transmission hanger, and tighten the 19 

bolts in two or more steps in a crisscross pattern.  

20. Install the mainshaft speed sensor (A) and countershaft speed sensor (B) with NEW O-rings (C). 

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

 

 

 

 

 

 

 

Content   ..  810  811  812  813   ..