Acura TSX / Honda Accord CL. Manual - part 774

10. Engage the park pawl with the park gear.  

11. Cut the lock tab (A) of the each shaft locknut (B) using a chisel (C). Then remove the locknuts and 

conical spring washers from each shaft. 

NOTE:

z

Countershaft and secondary shaft locknuts have left-hand threads.  

z

Keep all of the chiseled particles out of the transmission.  

z

Clean the old mainshaft and countershaft locknuts; they are used to 
install the press fit idler gear on the mainshaft, and park gear on the 
countershaft.  

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

Fig. 3: Cutting The Lock Tab Of The Each Shaft Locknut Using A Chisel 

12. Remove the special tool from the mainshaft.  

13. Set a two-jaw (or three-jaw) puller (A) on the countershaft (B) by putting a spacer (C) between the puller 

and countershaft, then remove the park gear (D). 

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

Fig. 4: Setting A Two-Jaw (Or Three-Jaw) Puller On The Countershaft 

14. Install a 6 x 1.0 mm bolts (A) on the mainshaft idler gear (B). Set a puller (C) on the mainshaft (D) with 

putting a spacer (E) between the puller and mainshaft, then remove the mainshaft idler gear. 

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

  

 

Fig. 5: Setting A Puller On The Mainshaft With Putting A Spacer Between The Puller And 
Mainshaft, Then Removing The Mainshaft Idler Gear 

15. Remove the park pawl, park pawl spring, park pawl shaft, and stop shaft.  

16. Remove the park lever from the control shaft.  

PARK LEVER STOP INSPECTION AND ADJUSTMENT 

1. Set the park lever in the P position.  

2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). 

Standard: 57.7-58.7 mm (2.27-2.31 in.)

 

2004 Acura TSX 

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX