|
|
BALL JOINT Removal 1. Install a hex nut (A) onto the threads of the ball joint (B). See Fig. 3 . Make sure the nut is flush with the ball joint pin end to prevent damage to the threaded end of the ball joint pin. 2. Apply grease to the special tool on the areas shown (A). See Fig. 4 . 3. Loosen the pressure bolt (A), and install the ball joint boot clip guide. See Fig. 5 . Insert the jaws carefully, making sure not to damage the ball joint boot. Adjust the jaw spacing by turning the adjusting 4. After adjusting the adjusting bolt, make sure the head (C) of the adjusting bolt is in the position shown to allow the jaw to pivot. 5. With a wrench, tighten the pressure bolt until the ball joint pin pops loose from the steering arm or knuckle. If necessary, apply penetrating type lubricant to loosen the ball joint pin. 6. Remove the tool, then remove the nut from the end of the ball joint pin, and pull the ball joint out of the steering arm or knuckle. Inspect the ball joint boot, and replace it if damaged. NOTE: Always use a ball joint remover to disconnect a ball joint. Do not strike the NOTE: Do not use pneumatic or electric tools on the pressure bolt.
2004 Acura TSX 2004 SUSPENSION Front - TSX
|